Blue Screen of Death

The blue screen of death is a mistake of any Windows user. It indicates fatal errors when a complete Windows crash occurs with no logging, tracing, logging, or any other indication of the device or program that caused the critical problem. The cause is usually traced to recent changes to hardware, drivers, or software that can be rolled back, updated, removed, replaced, or diagnosed using standard means to find a disk or file system error.

Here is a small table causes of blue screen of death and approximate methods of solving them.

Stop 0x0000000A Replace or remove the device, update or roll back the driver.

Stop 0x0000001E recently installed or poor-quality software glitch caused the operating sistemy.Otpravte bug report and update or remove software.

Stop 0x00000024 Probably a disk or file system error. Run CHKDSK to scan for disk errors.

Stop 0x0000002E Poor or inadequate memory, motherboard, second-level cache or RAM memory or video platy.Zamenite platu.Tak same parent may be caused by errors or swap file diska.Zapustite CHKDSK drive to find errors.

Stop 0x0000003F This problem can solve removal or reinstallation of software updates.

Stop 0x00000050 Replacing RAM, second-level RAM cache, video card RAM, or incompatible software, including antivirus or remote control software, may resolve the issue.

Stop 0x00000077 Run an antivirus scanner to find and eliminate possible virus infection. Run CHKDSK or another disk diagnostic and repair utility or replace the hard drive

Stop 0x00000079 This error most often occurs when changing the ACPI firmware settings. For example, you installed windows xp professional on an x86-based computer with the use of embedded hardware ACPI enabled, and then decided to disable it. Also, this error can occur when copying inappropriate configuration files of single-processor and multi-processor systems to the system. Enable ACPI or run Windows Setup to restore system files and ensure they match your hardware configuration.

Stop 0x0000007A Start CHKDSK or another disk diagnostics and recovery utility, or replace the hard disk drive or controller.

Stop 0x0000007B Critical 07B errors usually occur after installing incorrect device drivers when installing or updating a memory adapter. Also, critical 07B errors may indicate a possible virus infection. Run an antivirus program to scan your system for viruses.

Stop 0x0000007F This error may cause malfunctions or software errors devices.

Stop 0x0000009F message indicates that the selected driver selected type is invalid or incompatible zapuska.Perezahruzite computer.

Stop 0xBE remove or install updated drivers.

Stop 0xC2 Typically, this error message indicates the drivers or software.

Stop 0x000000CE This error indicates that the driver before disconnecting elected inconsistent or invalid startup type.

Stop 0x000000D1 This error usually cause drivers using the wrong address.

Stop 0x000000D8 This error usually cause drivers using the wrong address.

Stop 0x000000EA Remove and re-updated drivers, software or device.

Stop 0x000000ED This error can also occur when upgrading to Windows XP Professional on systems with hard drives or high-bandwidth ATA controllers if they are incorrectly connected. In some cases, the system works fine after a reboot. An 80-wire IDE cable can solve the problem.

Stop 0x000000F2 for devices and difference of level interrupt mistakenly assigned the same interrupt IRQ.

Stop 0x0000021A can not use the security system Windows.

Stop 0x00000221 Indicates driver errors, system file errors, or disk corruption (such as a corrupted swap file). Malfunctions can also cause this critical error

devices. Replace RAM or reset the paging file.

See the table and look for possible solutions to treat the blue screen of death